Specifications
Throat Diameter (1)
Nominal Impedance (2)
Minimum Impedance
Nominal Power Handling (3)
Continuous Power Handling (4)
Sensitivity (1W/1m) (5)
Frequency Range
Recommended Crossover (6)
Voice Coil Diameter
Winding Material
50 mm (2 in)
8 ohm
8.4 ohm
110 W
220 W
107.5 dB
0.5 -18 kHz
1 kHz
75 mm (3 in)
Aluminium
0.14 mH
Titanium
1.6 T
Inductance
Diaphragm Material
Flux Density
Mounting and Shipping Info
Four M6 holes 90° on 102 mm
(4 in) diameter
Overall Diameter
Depth
156 mm (6.1 in)
66 mm (2.6 in)
Net Weight (1 unit)
Shipping Weight (2 units)
Shipping Box (2 units)
4.1 kg (9.0 lb)
8.8 kg (19.3 lb)
210x210x190 mm
(8.3x8.3x7.5 in)
1
Driver mounted on B&C ME75 horn
2
Also available in 16 ohms, data upon request
3
2 hours test made with continuous pink noise signal (6 dB crest factor)
within the specified range . Power calculated on rated minimum
impedance.
4
HF Drivers
220 W continuous program power capacity
2” horn throat diameter
Power on Continuous Program is defined as 3 dB greater than the
Nominal rating.
DE64TN
5
6
Applied RMS Voltage is set to 2.83V for 8 ohms Nominal Impedance.
12 dB/oct. or higher slope high-pass filter.
75 mm (3 in) aluminium voice coil
500 – 18000 Hz response
107.5 dB sensitivity
Shorting copper cap for extended HF response
|