Installation Instructions / Warranty
Uno
14850001
Puro
14870001
Uno
14856001
Puro
14876001
Product Specification
Recommended water pressure
Recommended hot water temp
45 - 80 psi
1ꢀ0oF - 140oF*
Flow rate
Hole sizes
Faucet
ꢀ.ꢀ gpm
1 1/ꢀ”
Sidespray 1”
Max. mounting surface thickness
Faucet ꢀ ꢁ/8”
Sidespray 1 1/8”
ꢁ/8” supply hoses -- requires ꢁ/8” compression fittings (not included)
Sidespray faucets include double check valve
*Please know and follow all applicable plumbing codes when setting the temperature on the water heater.
Installation Considerations
For best results, Hansgrohe recommends installation by a licensed, professional plumber.
Large differences in pressure between the hot and cold supplies should be balanced.
The supply lines should be flushed thoroughly of building debris before installing this faucet.
The supply hoses on this faucet require stops with ꢁ/8” compression fittings (not included).
ꢁ
Install the faucet
Remove the plastic washer, fiber washer, friction washer,
and mounting nut from the faucet.
If the mounting surface is thicker than 1 ꢁ/8”, or if there
is insufficient space, discard the plastic washer.
plastic washer
fiber washer
From below the mounting surface, install the plastic wash-
er (if using), fiber washer, and friction washer. Install the
mounting nut, but do not tighten it completely.
friction washer
mounting nut
tensioning
screws
Inspect the placement of the faucet. Reposition if neces-
sary.
When satisifed, finish tightening the mounting nut.
Tighten the tensioning screws.
fiber washer
friction washer
mounting nut
tensioning
screws
Connect the hoses to the stops using ꢁ/8” compression
fittings (not included). Use two wrenches, as shown in
the diagram, to prevent the hoses from twisting or from
becoming loosened from the faucet.
For proper operation of the faucet, the hot supply should
be on the left, and the cold supply should be on the right.
4
Install the sidespray (sidespray models
only)
Position the sidespray holder on the mounting surface.
Install and tighten the mounting nut.
Thread the sidespray hose through the handspray holder.
Sit the sidespray in the holder.
Install the double check valve adapter with washer on the
sidespray connection on the faucet.
Connect the sidespray hose to the adapter. Hold the
adapter firmly with one wrench while tightening the hose
nut with a second wrench.
Turn on the water and check all connections for
leaks.
washer
adapter
sidespray hose
User Instructions
Pivot the handle out to turn the water on. Pivot it forward to make the water cooler, to the rear to
make it warmer.
To use the sidespray, turn the water on. Pull the sidespray out of the holder. Press and hold the
trigger on the back of the sidespray.
Water will still come from the spout when the sidespray is turned on.
5
Re-set the High Temperature Limit Stop (optional)
Close the drain OR cover it with a wash cloth.
Use the included 4 mm Allen wrench to push the
screw cover into the handle. Retrieve the screw
cover when the handle is removed.
Use the 4mm Allen wrench to loosen the handle
screw 4 complete revolutions. Remove the
handle and put it in a safe place.
Remove the decorative nut cover and put it in a
safe place.
Remove the handle screw from the stem of the
cartridge. Remove the high temperature limit
stop.
Replace the high temperature limit stop so that
the pin on the cartridge is in the desired slot on
the limit stop. Note: the temperatures given in
the diagram assume a water heater temperature
o
o
of 140 F, a cold water temperature of 50 F
and a water pressure of 45 PSI.
Replace the decorative nut cover. Replace the handle screw. Use the Allen wrench to turn the
screw 4 revolutions.
Replace the handle. Finish tightening the handle screw. Turn on the water and test the faucet.
6
Replacement Parts
14870001 / 14876001
14850001 / 14856001
1.1
10
10
1
17
5
7
5
9
11
8
8
9
ꢀ
ꢁ
16
11
4
16
1.1
4
ꢁ
ꢀ
1ꢀ
6
1ꢁ
6
14
15
7
Replacement Parts (continued from p. 7)
1
handle
10490000
96ꢁꢁ8000
96468000
96461000
9ꢀ7ꢁ0000
1ꢁ91ꢁ000
95049000
9ꢀ8ꢁ0000
9ꢀ646000
97558000
9766ꢀ000
96059000
06ꢁꢀ7000
94074000
88504000
88506000
95008000
96514000
1.1 screw cover
ꢀ
ꢁ
4
5
6
7
8
9
flange
nut
cartridge
aerator
fixing set
spout
sealing set
axial ring
10 screw
11 handle screw
1ꢀ handspray
1ꢁ check valve
14 flange
15 nut
16 seal
17 spout
8
Cleaning Recommendation for Hansgrohe Products
Modern sanitary faucetry and shower fixtures consist of very different materials to comply with the needs of the market with
regard to design and functionality.
To avoid damage and returns, it is necessary to consider certain points when cleaning:
Cleaning materials for faucets and shower products:
Acids are necessary ingredients of cleaning materials for removing lime. However, please pay attention to the following points
when cleaning faucets and shower products:
•
•
Use only cleaning materials intended for the application.
Never use cleaning materials which contain hydrochloric, formic, or phosphoric, or acetic acid, as these can cause
considerable damage.
Do not mix one cleaning material with another.
Do not use abrasives, such as cleaning powders, sponge pads, or microfiber cloths.
•
•
Cleaning Instructions for Faucets and Shower Products:
Please follow the cleaning material manufacturer’s instructions. In addition, please note the following:
•
•
•
•
Clean your faucets and shower products as and when required.
Follow the label instructions. Do not allow any cleaner to remain on the product for longer than necessary.
Regular cleaning will prevent scale buildup and water spotting.
When using spray cleaners, spray first onto a sponge or cloth. Do not spray directly onto the faucet or shower product
as drops could enter openings or gaps and cause damage.
After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
•
Important
Residues of liquid soaps, shampoos, and shower foams can also cause damage, so rinse with clean water after using.
Please note:
•
•
•
If the surface is already damaged, the effect of cleaning materials will cause further damage.
Components with damaged surfaces must be replaced, otherwise, this could cause injury.
Damage caused by improper treatment will not be covered by our warranty.
9
Limited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to
Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or
Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material or workmanship
as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of the product which proves defective
because of improper workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe is unable to provide a
replacement and repair is not practical or cannot be timely made, Hansgrohe may elect to refund the purchase price in exchange for the return of
the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences. If you are a
consumer who purchased the product for use primarily for personal, family, or household purposes, this warranty extends for as long as you own
the product and the home in which the product is installed. If you purchased the product for use primarily for any other purpose, including, without
limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Interaktiv and Retroaktiv products, and (ii) for 5 years,
with respect to AXOR, ShowerPower and Pharo products.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A.
B.
Conditions, malfunctions or damage not resulting from defects in material or workmanship.
Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident
or alteration, or (ꢀ) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner
contrary to the product instructions.
C.
D.
Labor or other expenses for the disconnection or return of the product for warranty service, or for installation or reinstallation of the product.
Accessories or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY SERVICE
Contact your Hansgrohe retailer, or write to Technical Service at:
Hansgrohe Inc.
149ꢀ Bluegrass Lakes Parkway
Alpharetta GA ꢁ0004
Or, call Hansgrohe toll-free at (800) ꢁꢁ4-0455.
In requesting warranty service, you will need to provide
1.
ꢀ.
ꢁ.
The sales receipt or other evidence of the date and place of purchase.
A description of the problem.
Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 149ꢀ Bluegrass Lakes
Parkway, Alpharetta, Georgia ꢁ0004, Attention: Technical Service, if required by Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS
THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY
OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES,
ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to
you.
10
This warranty gives you specific legal rights, and you may have other rights which vary from State to State.
You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you can bring any action in court
against us under the Magnuson-Moss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect. Prior to installing, always
carefully study the enclosed instructions on the proper installation and the care and maintenance of the product. If you have questions at any time
about the use, installation, or performance of your Hansgrohe product, or this warranty, please call or write to us at the toll-free number and address
printed above.
11
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA ꢁ0004
Tel. 770 ꢁ60-9880 • Fax 770 ꢁ60 9887
www.hansgrohe-USA.com
|